Challenge yourselves in the backcountry with the NEW129FR. Designed with a fanatical attention to detail, the Yeti 129 FR is the lightest, toughest, most responsive system that gives you the agility you’re looking for in the powder.
A 12.5-inch wide track on 5.5-inch narrow rail chassis gives riders more track floatation with the agile feel of a narrower system.
2.5-inch paddles for bringing better lift and traction in deep snow.
Optimized internal/external sprockets allow lower track tension for increased grip even in the deepest snow.
A stronger chassis with local reinforcement to dissipate the stress under high load.
The new YETI 129 FR using pure carbon fibre strategically reinforced with aircraft grade aluminum. With a shorter track, the Yeti 129 FR sheds weight, not strength. Its new drive sprocket design produces less rolling resistance with lower track tension to maximize horsepower output where the rubber meets the snow. Limitless potential to ride and rip it in open meadows, carve through tight tree lines and climb steep hills.
$9,699 CAD - $7,699 USD
FEATURES & BENEFITS
ELKA SHOCK - STAGE 3
Allows low speed compression adjustment to adapt different types of riders.
2.86 NO-SLIP DRIVERS
Higher load capacity at lower track tension to avoid ice buildup
An industry first “SOFT STRUT” providing 1/2'' of movement adding compliance under heavy load without affecting deep snow performance.
DUAL-PISTON CALIPER BRAKES
HAYES pre-bleed brake system to ensure ideal brake performance.
CAMSO SNOW BIKE TRACK
Lightweight 129-inch track, 12.5 inches wide and deep 2.5 inch lugs.
PRE-BLEED BRAKE SYSTEM
Comes from the factory with a 11mm master cylinder calibrated with brake caliper. Progressive and smooth brake feel. Reduced installation time without bleeding needed!
dIMENSIONS & WEIGHT
Estimated Dry Weight-Front
Estimated Dry Weight-Rear
Camso Snowbike Track
CHASSIS & DRIVE SYSTEM
Carbon Fibre/NEW Clear gel coat
Automatic Chain Tensioner
NEW Hayes V32 - Dual Piston Caliper, sheilded rotor with anti-rattle pad clip
NEW Hayes pre-bled, Right Hand, 11mm piston
Syncrodrive, Belt drive system
Mitsuboshi 28 mm Width/896 mm length
Quick Access Belt Drive
DID520VOX 60 or 62 Link (master link)
1 1/16" Hex, Titanium, 7 tooth Anti-ratchet sprocket
Drive Shaft Sprocket
16 tooth- Splined
Upper Syncrodrive Belt Drive Gear
41 tooth- Splined
Lower Syncrodrive Belt Gear
47 tooth- Splined
Hardware & Fasteners
Titanium, Anodized Aluminum & Stainless Steel
Front & Rear Shock
Elka shock Stage 3
Titanium reactor Arms
Front Suspension Arm
Powder Coated Steel w/ STRENX reinforcements
11.0" (28 cm)
Yeti Soft Strut
Parabolic design, 20" Radius
Hardox, Zinc Plated